Input what side / outputs side to electroanalysis capacitance computation

Input what side / outputs side to electroanalysis capacitance computation

[introduction] we are general according to in the input voltage falls, below the circumstance of output, the requirement electroanalysises the ripple voltage on capacitance is calculated under how many percent. Of course, if have the demand that holds time, need to ask according to what hold time so recount, in both, take big cost.

Input side electroanalysis capacitance computation

We are general according to in the input voltage falls, below the circumstance of output, the requirement electroanalysises the ripple voltage on capacitance is calculated under how many percent. Of course, if have the demand that holds time, need to ask according to what hold time so recount, in both, take big cost.

If be below input voltage, the power input of power source is Pin, virtual value of input alternating voltage is Vinacmin, so we think right now the volts d.c. after rectification is Vinmin=1.2 × commonly Vinacmin, because be in,communication charges twice between cycle, right from the back the power supply of transformer is by capacitance store will assure, so it is OK that voltage declines computation comes out:

T of Δ of × of V=I of C × Δ ,

Δ V is voltage ripple, the 10% ~ that take Vinmin commonly 20% , I is capacitance is opposite from the back the =Pin/Vinmin of discharge electric current of circuit

And Δ T is charging time-interval two (the discharge time that is the capacitance inside cycle of frequency of a labour) , can consider according to Fac) of × of 0.8 × 1/(2, spoken parts in an opera, in the half sine cycle after communicating rectification namely, the time of 80% is to rely on to electroanalysis capacitance store will supply the transformer from the back.

Input what side / outputs side to electroanalysis capacitance computation

So from this we can be calculated wave of the filter after giving the communication commutate that inputs end electroanalysises capacitance capacity.

Those who output side electroanalysis capacitance computation

Those who output side electroanalysis capacitance. Those who output end electroanalysis capacitance job is in high frequency below, ripple electric current is very big to its influence, we calculate those who output side to electroanalysis commonly according to the limitative condition of ripple electric current capacitance.

Electroanalysis the voltaic virtual value of the virtual value of ripple electric current on capacitance and sub commutate diode and the relation that export electricity are:

Input what side / outputs side to electroanalysis capacitance computation

Electroanalysis the manufacturer home of capacitance can give out normally electroanalysis capacitance falls in a certain frequency, the IRCrms of rated ripple electric current when a certain temperature. But in using a process actually, we need to consider temperature effect and frequency effect. The ripple electricity that practical electric capacity can use is coefficient of frequency of IRCrms × temperature coefficient × . Different manufacturer, offer temperature coefficient and frequency coefficient reference point to may differ, want to notice conversion. If the manufacturer was not offerred, so the numerical value below can offer reference:

Temperature coefficient:

105 ℃ : 1
85 ℃ : 1.7
65 ℃ : 2.1

Frequency coefficient:

100KHz: 1
10KHz: 0.9
1KHz: 0.8
120Hz: 0.5
50Hz: 0.32

Individual if ripple electric current is insufficient,electroanalysis, can use with many paralell connection. Additional, many paralell connection are used also conduce to reduce output voltage ripple.

Electroanalysis actually eventually the choice of capacitance is right, besides should make sure enough voltage abundant is measured. Mainer is to electroanalysis the temperature of capacitance and temperature rise. Electroanalysis the temperature of capacitance every are elevatory 10 degrees, so life halve. Electroanalysis so the working temperature of capacitance, the limitation that is designed life by power source.

On the other hand, because may ab extra quantity of heat causes the temperature rise of capacitance, the loss that also may be oneself causes. So, there still is requirement of a limitation here, namely, from ℃ of temperature rise <5.

Avoid duty statement: The article is reprint an article, reprint this article purpose to depend on passing more information, the person that copyright puts in original work ‘s charge is all. If involve work copyright issue,article place uses video, picture, written language, contact please small make up undertake handling.

Leave a Reply

Your email address will not be published. Required fields are marked *